Never had problems with adjusting the ride height either too low or high (Gaz coilovers). My main issue was setting the height and maintaining a decent level of 'hardness'. Changed to 10.5" 300lb springs recently from Rally Designs and this felt much better.
I think my ride height is about 140mm.
Regarding the rear bodywork, I noticed recently that the drivers side wheel outside edge was flush with the rear arch but the nearside was slightly inset by about 10-15mm. They are both set at 3mm (1°) negative camber and don't protrude beyond the bodywork.
Looking at your photos, have the rear arches been modified at some point as mine have a 1" flat edge which yours don't appear to have...
I have found that the suspension set-up is all about compromise i.e. Hardness, bump steer control, ride height, wheel alignment, wishbone/driveshaft alignment and wheel to arch clearance!
Maybe post some more photos including the spring/damper set-up as it might help our understanding of your problem.
|
Hybrid Mode
