After the longest build in history and many life events later, I found a few spare hours to tidy up the car in preparation for IVA. I would value all tips from all of you that have negotiated and got through the test. Some photos from today.
I can't quite see from the photos, but it would appear the mudguard edges (in particular the front edges of the front mudguards) may be too sharp. They may need either return edges, or at least a radius to blunt them - worth checking the manual.
Something things that might help, this is from the SVA days - from 2007 so some things may have changed since then:
Bottom of the dash radius - I used pipe insulation foam covered in interior fabric
Car front / rear axle weights
Any sheet metal, inc the bonnet edges need rubber on them
Check for any brake lines near the exhaust and add heat shielding if needed
Mirrors - check the current rules make sure you can see, I needed convex glass to pass the test (I then later changed to bullet style mirrors with convex, but they'd have failed due to surface area size)
One of the check they do it a emergency stop test to make sure the front locks before the rears
Check the exhaust tips are not within the radius cones/test area. If they are they need to pass the radius test. I added a bar to the rear of the car so the exhaust tips were outside the testable area. (See: https://www.msportster.co.uk/2007/08...-sva-proofing/)