Sportster Brake Master Cylinder

[Grey V8 Pete]

Originally Posted by peterux

Hi Peter,
Did you have an issue with this master cylinder?
Cheers, Peter

Hi Peter.
I did cut a small amount off the redundant front solid boss to ensure adequate clearance with the bonnet. If I can attach two photos they show the cut line which is the inner blue line in each case. That said, as my bulkhead is flat where the servo is mounted, I had already used packing washers to mount the new dual servo to get clearance. Peter.

[peterux]

Originally Posted by Grey V8 Pete

Hi Peter.
I did cut a small amount off the redundant front solid boss to ensure adequate clearance with the bonnet. If I can attach two photos they show the cut line which is the inner blue line in each case. That said, as my bulkhead is flat where the servo is mounted, I had already used packing washers to mount the new dual servo to get clearance. Peter.

Thanks Peter, but you mentioned another issue on the MOC forum? Perhaps this is now resolved?

[Grey V8 Pete]

Yes. The other issue was a red herring! Peter.

[peterux]

Anyone still looking might be interested in this...
https://www.ebay.co.uk/itm/BRAND-NEW...-127635-2958-0