Plugs.

[Rebelervi]

So...having had an interest in fabrication, I have been attempting to create panels for my own projects.
Made a few mistakes...but found it to be mostly rewarding.

Circumstances have left my better half and myself waiting on relocating, house contents mostly packed/boxed for last two years, move in progress for five.

Decided to purchase Spitfire as a base car.
Changed suspension.
Used the Triumph 2.5 S, wanted re designed front grill, quarter panels, none available, phoned local shop, they said I'd need a plug.
Made one from filler/ re claimed wood, took to another GRP company, who persuaded me to give fiber glassing ago, and offered me employment...yay.
Molded plugs, gave quater panels deep draught, took all day to release,
still....once fitted took car to a company who offered contract..in principle...subject to alterations, clearance related.



Decided to carry on experimenting, made a roof:



Junked, but kept some panels, built again, wooden skeleton, for rough idea of lines, templates across.

[Rebelervi]

Found that there was a 8mm difference in car, from centre.


One of my favorite tools has to be the Grinder....






Wrong trousers?

[Rebelervi]

Framed area for molding.


Layed up rear with Four plus layers of Gelcoat, Choppings, chopped strand matt 600, two layers, up to laminate wood divide, with locators.




Found that using one layer of release wax, on plug surface, before using sticky tape kept finish un damaged.
Cut laminate for divide, drilled edges, used filler to tape, trimmed with chisel, waxed etc.





Molded side vents separately, filled over to lay up rear.
After sections were laid up to two layers of 600, sanded, then continued at two layers a day/ sanding, till the mold was a bout twelve layers.

[Rebelervi]

Was thinking of rear mounted rad', diffuser, and wing.


Added plastic strip.


Brought sides round.


Ply for edge, strips to add filler on.



Added light bases..

[Rebelervi]

Set licence plate flush, built surfaces up.


Shaped ply for inner line, filled to outer edges.


Decided it was too thick.



Now why didn't I just stack those lights....


One of the Templates made, added release wax to plug, sticky taped the line to capture, cut wood roughly to match, drilled edges, added filler, held to line.
When set, angled back edge.

[Rebelervi]

Felt the need to cut away.


Had a go at a rear channel-ling section..later scrapped.
Same deal, ply, filler.


Reset lights, cut inner bracketing for adjustable wing. Rounded edges.

[w3526602]

Sir, you have a gift!

<<<Would like to move engine rear wards>>>
I THOUGHT about moving moving a small Triumph engine back a few inches, but many years ago and I don't have your skills. The easy way SEEMS to be to reverse/swap the front suspension turrets over, which would move the engine supports back a bit, using spanners ... but I don't know if its that easy. Another problem was that the clutch housing is too big to move back, as chassis rails get closer together. But look at the MG Midget 1500, which shares the Spitfire engine. I believe there is very limited space in the MG transmission tunnel.

I often wondered about extending the Spitfire rear suspension tie-bars forward to connect with the chassis, which would take the floor pans out of the MOT equation.

Power to your elbow.

602

[mas123mas]

Very Talented, excellent work