How about the horizontal datum line
You might want to check the distance between the wheel arch and the bottom of the door shut measured horizontally. On mine, if I continue the line level with the bottom of the door shut, backwards until it hits the rear arch there appears to be 2cm difference.
I spent an afternoon trying to line up the body after I fitted metal plates behind the door slam panel that are to be tack welded onto the end of the flat angle on the frame. The drivers side rested perfectly leaving just enough overlap to weld the plate and the frame together. On the passenger side the plate was about 1cm behind the frame.
After much measuring of the frame, the body inner, pushing, shoving, swearing I finally measured the out shell and discovered the difference.
This was just before I went on holiday and i haven't looked since so there is a chance i was just having a bad day when I discovered thgis. I will be checking again at the weekend.
|