Ok, I'm digging up some real old threads here but I'm only just starting to play with my engine.. someone might find it of use
I've removed the air conditioning pump.
Removed the water/power steeting pump combo. Separated the water / power steering. Removed the four allen head set screws holding the power steering pump together. With pump chassis resting on vice so the shaft is free and the pulley end facing down, whacked the centre with a piece of dowl. Pump comes apart.
Removed the needle bearings and various parts inside the pump. Filled up the inlet and outlet holes. Painted the two halfs. The bearings appear to be sealed but just to be on the safe side I put a small amount of oil in side the pump casing then bonded it back together. Put the allen head set screws back in, and used hammer/wood to fix the end back on the shaft - there doesn't seem to be anything actually holding the shaft & pulley on the pump, just a tight fit!
Just gotta figure out how to get this all to work now with a shorter aux belt
|