View Single Post
  #30  
Old 15th December 2022, 16:55
peterux's Avatar
peterux peterux is offline
Senior Member
Enthusiast
 
Join Date: Mar 2005
Posts: 3,074
peterux is on a distinguished road
Default

Quote:
Originally Posted by Grey V8 Pete View Post
Hi Peter.
I did cut a small amount off the redundant front solid boss to ensure adequate clearance with the bonnet. If I can attach two photos they show the cut line which is the inner blue line in each case. That said, as my bulkhead is flat where the servo is mounted, I had already used packing washers to mount the new dual servo to get clearance. Peter.
Thanks Peter, but you mentioned another issue on the MOC forum? Perhaps this is now resolved?

Last edited by peterux; 15th December 2022 at 16:56.. Reason: grammer
Reply With Quote