Dave - Guilty as charged m'lud.
Funnily enough, I was actually think along those lines very recently.
As it dawned on me that I might be the only Sammio with a 3 level horizontal join at the sides.
Reading other builds, most people join the floors to the side and then go straight to the internal panels.
Although in my defence, I really can't align the internal panels in the traditional way due to a combination of "wonky" factors.
Still, despite the over engineering, I must confess that I really like how solid the body work feels.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Wet & Windy:
There was just brief chance to work outside late this afternoon.
I tried to take some more photos of the Tiger Seal joins on either side of the bulkhead, but they are still not great.
I had to use the lowered floor pans to lay out the fibreglass matting to keep it out of the wind.
Just before I started putting this lot in place the street lights came on.
So it was pretty dark by the time I'd finished, so the flash was required.
With a bit of luck, I will be able to bond the next round of panels in tomorrow.
Until then, take care, Paul.
