Framed area for molding.
Layed up rear with Four plus layers of Gelcoat, Choppings, chopped strand matt 600, two layers, up to laminate wood divide, with locators.
Found that using one layer of release wax, on plug surface, before using sticky tape kept finish un damaged.
Cut laminate for divide, drilled edges, used filler to tape, trimmed with chisel, waxed etc.
Molded side vents separately, filled over to lay up rear.
After sections were laid up to two layers of 600, sanded, then continued at two layers a day/ sanding, till the mold was a bout twelve layers.
