Quote:
Originally Posted by MartinClan
I think that it is just to clear the slightly raised area caused by the fixing of the studs to the servo. Just so the adapter plate lies flat against the face of the servo.
Robin
|
Correct!
The studs are fixed by what look like giant rivnut bases, which have a slightly raised base (< 1mm). The problem then is this base is 15mm diameter. I found the adaptor plate rocked on these, so have asked for a very shallow countersink to clear 16mm at the base, but remain 11mm at the nut face
You are getting a properly enginneered product !
Mike