3rd May 2023, 18:38
|
Senior Member
|
|
Join Date: Nov 2012
Posts: 845
|
|
Headlights and tank.
Yesterday, having trimmed off the surplus fabric around my Monaco tonneau cover, I decided to make the headlight support brackets, thinking this would be a five minute job . Far from it. Having offered up the flip front to gauge access to the front frame, I dug out one headlamp bucket and pondered the appropriate size mounting. The 13mm mounting post thread with its hefty washers decided me against 1" box or angle, a pity as that is the size of the top rail to which it would be welded. Digging out and offering up some 1.5" angle looked OK, if welded under the front of the top rail. Lots of discing, filing and (especially) drilling later the N/S one was g-clamped on with a redundant sealed beam unit in place to view the effect. It was satisfactory. I took a picture but accidently deleted today .
Regards, Mick
Last edited by Mick O'Malley; 21st July 2023 at 13:57..
Reason: Typos.
|