my berlinetta so far, 2lt pinto
 

There's not a lot of room to work in for this kind of job, its nearly ready to be stripped down again now i know how it all fits together, every thing is drilled and over sized bolted just to be sure it all stays together, I'm just on with building the dash and centre console, once that is fitted and I'm happy with it the strip down will begin. because i want to re paint the hole chassis again.
http://i49.photobucket.com/albums/f2...arlin039-2.jpg
http://i49.photobucket.com/albums/f2...arlin040-1.jpg
http://i49.photobucket.com/albums/f2...arlin006-1.jpg
http://i49.photobucket.com/albums/f2...arlin008-3.jpg

http://i49.photobucket.com/albums/f2...1ohc_page7.jpg

Your Berlinettad
 

Hi
Looking good, you will enjoy it when its on the road :wave:

MikeMF

http://classickitcargroup.zxq.net/

finally got started on the dash board coming along nicely.the clocks are smith classics, it all pulls together nice and tight when the screws are in, iv left the main screws out for now while i make adjustments, i still have the glove box stereo and heater controls to cut out of the dash, and the junk box to cut from the centre console. not being a joiner myself i didn't realise how much work there was just to get to this stage.
http://i49.photobucket.com/albums/f2...arlin003-4.jpg
http://i49.photobucket.com/albums/f2...arlin001-5.jpg
http://i49.photobucket.com/albums/f2...arlin004-4.jpg