This is a read-only archive of the old Madabout Kitcars forum. New posts and replies are no longer possible, but every thread is still here to browse and read.
I'm about to rebuild the bottom end of my GT6 engine but I'm unsure what main and big end bearings to fit? There seems to be lots of debate about bearing quality and I was wonder if anyone has any experience or advice on bearing manufacturer or supplier...
From what I gather, the county bearings are the most common cheap bi-metal but may be sufficient for a standard low mileage engine application? Do I need to or should I consider more expensive bearings?
I'm about to rebuild the bottom end of my GT6 engine but I'm unsure what main and big end bearings to fit? There seems to be lots of debate about bearing quality and I was wonder if anyone has any experience or advice on bearing manufacturer or supplier...
From what I gather, the county bearings are the most common cheap bi-metal but may be sufficient for a standard low mileage engine application? Do I need to or should I consider more expensive bearings?