MadaboutKitcars

Hi
Here's one for the Rover Turbo boyos
I have here a newly reconned T28
It has been based around T25 covers, so looks stock, but houses larger wheels etc.
It made just over 300hp on a customers car before he upgraded to a GT30.
It was then sent off to be reconned and hasn't been used since.
It runs a bored .64 housing to take the pulsar turbine wheel.
60 trim comp wheel which is the same as pulsar, with a bored compressor housing. 360 bearing and a gapless ring
It would run 24 psi all day.
So in other words - all the benefits of a Pulsar without the lag
Looking for around £300 but open to offers.

PM or email me on [email]grant@gb-ent.com[/email]

Hi Grant, what else would you need apart from this to get 300 bhp out of the standard Rover Turbo engine ? Can the standard engine handle 300 bhp ?

thanks

Nick

Hi. You would need to replace the pistons and rods unfortunately.
Would also need a replacement management system (DTA, Autronic, etc.)

I think that might be something for the future then, thanks

Sold