Work to date has been fabricating the doot hinges for the passenger side, which is a full 2 inches different in position to the Drivers side.
I would have liked to have had the skill to produce something like this:
However my skills and tooling are limited so I have only been able to produce this:
Passenger
Drivers
The reinforcing plates for the door catch have now been welded in place.
I am planning to use the old scimitar catches, but it will remain to see if they are anti bust catches, when i finally get on the road and hit a few potholes on a sharp bend.
I have not yet figured out how I am going to fit a beam in the door and mount fasten it to the hinges, door and lock/catch.
HM