Time for another version of the radiator bracket! Its now bolted along the sides with two strips of metal either side of the rad. Bolts need shortening to and a lick of paint to clean it up.
All the water pipes for the front of then engine are now cut to size and routed. Currently the bottom pipe is zip tied to the bottom of the radiator - I'd like to find a more elegant solution for this but it will do for the moment.
Oil pipe test fit, not sure yet how we're going to run these so these are just where they will fit at the moment. The oil cooler connectors we have are the straight type so are most suitable for running the pips this way. 180 degreee connector would work for going under and along. More research need on this one!